Dell S6000 Reference Manual page 756

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.5.1.0

Enter the following keywords and slot/port or number

information, the valid range of slot number is from 0 to 5:

For a Loopback interface, enter the keyword Loopback

then a number from 0 to 16383.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For the Management interface, enter the keyword

ManagementEthernet then zero (0).

For the Null interface, enter the keyword null then zero

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a stack-unit interface, enter the keyword stack-

unit then the stack unit number. The range is from 0 to

For a tunnel interface, enter the keyword tunnel then

the tunnel interface number. The range is from 1 to

For a VLAN, enter the keyword vlan then a number from

(OPTIONAL) Enter the keyword brief to view a brief

summary of the interfaces and whether an IP address is

(OPTIONAL) Enter the keyword configured to display the

physical interfaces with non-default configurations only.

EXEC Privilege

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

IPv4 Routing