Dell S6000 Reference Manual page 785

l2acl 1-4
ipv4acl 1- 4
ipv6acl 0-4
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.2.0
Version 8.2.1.0
Version 7.8.1.0
Usage
For the new settings to take effect, save the new CAM settings to the startup-
Information
config (write-mem or copy run start), then reload the system.
The total amount of space allowed is 4 FP Blocks.
Example
Dell#
Dell#configure
Dell(conf)#cam-acl-egress ?
default
l2acl
Dell(conf)#cam-acl-egress l2acl ?
<1-4>
Dell(conf)#cam-acl-egress l2acl 1 ?
ipv4acl
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4>
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
IPv6 Access Control Lists (IPv6 ACLs)
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series TeraScale.
Introduced on the S-Series.
Introduced on the C-Series.
Reset Egress CAM ACL entries to default setting
Set L2-ACL entries
Number of FP blocks for l2acl
Set IPV4-ACL entries
Set IPV6-ACL entries
Number of FP blocks for IPV6 (multiples of 2)
785