Dell S6000 Reference Manual page 799

route-map
map-name
Defaults Not configured.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 7.5.1.0
Version 6.3.1.0
Usage
When you use this command to redistribute routes into a routing domain, the
Information
router becomes an autonomous system (AS) boundary router. An AS boundary
router does not always generate a default route into a routing domain. The router
still requires its own default route before it can generate one.
How a metric value assigned to a default route advertises depends on the metric-
style command configuration. If the metric-style command is set for Narrow
mode and the metric value in the default-information originate command
is set to a number higher than 63, the metric value advertised in the LSPs is 63. If
the metric-style command is set for Wide mode, the metric value in the
default-information originate command is advertised.
Related
•
Commands
•
•
•
Intermediate System to Intermediate System (IS-IS)
(OPTIONAL) A default route the routing process generates if
the route map is satisfied.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added IPv6 ISIS support.
Introduced.
redistribute — redistributes routes from one routing domain to another routing
domain.
isis metric — configures a metric for an interface.
metric-style — sets the metric style for the router.
show isis database — displays the IS-IS link state database.
799