Ip Msdp Log-Adjacency-Changes - Dell S6000 Reference Manual

Parameters
peer address
list name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.4.1.0
Usage If a list is not specified, all SA messages received from the default peer are
Information accepted. You can enter multiple default peer commands.

ip msdp log-adjacency-changes

Enable logging of MSDP adjacency changes.
S6000
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
928
Enter the peer address in a dotted decimal format (A.B.C.D.)
Enter the keywords list name and specify a standard
access list that contains the RP address that should be
treated as the default peer. If no access list is specified, then
all SAs from the peer are accepted.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the list option and removed the prefix-list
option.
Introduced
Multicast Source Discovery Protocol (MSDP)