Show Crypto - Dell S6000 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
If you configure a VRF for an SSH session, then you need not explicitly mention the
Information
same VRF for the SSH client sessions intended for that VRF. The vrf attribute in the
ip ssh vrf command is applicable for both the SSH client as well as the COPY
(SCP) commands.
Example
Dell(conf)#ip ssh vrf vrf1
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh vrf vrf1

show crypto

Display the public part of the SSH host-keys.
S6000
Syntax
show crypto key mypubkey {rsa | rsa1}
Parameters
Key
mypubkey
rsa
rsa1
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1296
Introduced on the S-Series and Z-Series.
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
Enter the keyword key to display the host public key.
Enter the keyword mypubkey to display the host public key.
Enter the keyword rsa to display the host SSHv2 RSA public
key.
Enter the keyword rsa1 to display the host SSHv1 RSA public
key.
NOTE: If you enable FIPS mode, this parameter is not
available.
Security