Show Vlt Brief - Dell S6000 Reference Manual

Default 32768
Command VLT DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.8.0
Usage After you configure the VLT domain on each peer switch on both sides of the
Information interconnect trunk, by default, the Dell Networking OS software elects a primary
and secondary VLT peer device. To reconfigure the primary role of VLT peer
switches, use the priority command.

show vlt brief

Displays summarized status information about VLT domains currently configured on the switch.
S6000
Syntax
show vlt brief
Default Not configured.
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
1468
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Virtual Link Trunking (VLT)