Dell S6000 Reference Manual page 646

Usage When creating an interface range, interfaces appear in the order they are entered;
Information they are not sorted. The command verifies that interfaces are present (physical) or
configured (logical).
Important Points to Remember:
•
•
•
•
•
Example (Bulk)
Dell(conf)#interface range so 2/0-1, te 10/0, gi 3/0, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
Dell(conf)#interface range gi 2/0 - 23, gi 2/1 - 10
(Multiple Ports)
Dell(conf-if-range-gi-2/0-23#
Example
Dell(conf)#interface range gi 2/1 - 11, gi 2/1 - 23
(Overlapping
Dell(conf-if-range-gi-2/1-23#
Ports)
Usage
Only VLAN and port-channel interfaces created using the interface vlan and
Information
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature of
the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
Example (Single
This example shows a single range bulk configuration.
Range)
Dell(config)# interface range gigabitethernet 5/1 - 23
Dell(config-if-range)# no shutdown
Dell(config-if-range)#
646
Bulk configuration is created if at least one interface is valid.
Non-existing interfaces are excluded from the bulk configuration with a
warning message.
The interface range prompt includes interface types with slot/port
information for valid interfaces. The prompt allows for a maximum of 32
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
NOTE: If a range has VLAN, physical, port-channel, and SONET interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN, port-channel, or SONET, only those respective
interfaces should be configured in a particular range.
Interfaces