Dell S6000 Reference Manual page 872

static
aging-time
interface
interface
interface
interface-type
vlan vlan-id
count
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.12.0
Version 8.5.1.0
Version 8.3.7.0
872
(OPTIONAL) Enter the keyword static to display only those
MAC addresses specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
Enter the keyword aging-time to display only aging-time
information.
(OPTIONAL) Enter the keyword interface then the
interface type, slot and port information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
(OPTIONAL) Instead of entering the keyword interface
then the interface type, slot and port information, as above,
you can enter the interface type, then just a slot number.
(OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1
to 4094.
(OPTIONAL) Enter the keyword count, then optionally, by an
interface or VLAN ID, to display total or interface-specific
static addresses, dynamic addresses, and MAC addresses in
use.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Updated the output.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Layer 2