Dell S6000 Reference Manual page 1338

Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The following example configures a community named public that is mapped to
Information the security named guestuser with Read Only (ro) permissions.
The security-name parameter maps the community string to an SNMPv3 user/
security name as defined by the community MIB.
If a community string is configured without a security-name (for example,
snmp-server community public ro), the community is mapped to a default
security-name/group:
•
•
The community-name parameter indexes this command.
If you do not configure the snmp-server community command, you cannot
query SNMP data. Only Standard IPv4 ACL and IPv6 ACL is supported in the
optional access-list-name.
The command options ipv6, security-name, and access-list-name are
recursive. In other words, each option can, in turn, accept any of the three options
as a sub-option, and each of those sub-options can accept any of the three sub-
options as a sub-option, and so forth. The second Example shows the creation of a
standard IPv4 ACL called snmp-ro-acl and then assigning it to the SNMP
community guest.
1338
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
v1v2creadu / v1v2creadg — maps to a community with ro (read-only)
permissions.
v1v2cwriteu/ v1v2cwriteg — maps to a community with rw (read-write)
permissions.
Simple Network Management Protocol (SNMP) and Syslog