Dell S6000 Reference Manual page 727

Version 7.6.1.0
Version 7.5.1.0
Version 6.3.1.0
Usage This command disables the incrementing of the hops field when boot requests are
Information relayed to a DHCP server through Dell Networking OS. If the incoming boot
request already has a non-zero hops field, the message is relayed with the same
value for hops. However, the message is discarded if the hops field exceeds 16, to
comply with the relay agent behavior specified in RFC 1542.
Related
ip helper-address
Commands
server requests.
show running-config
default values.
ip host
Assign a name and IP address the host-to-IP address mapping table uses.
S6000
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name
ip address
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
IPv4 Routing
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
— specifies the destination broadcast or host address for DHCP
— displays the current configuration and changes from the
Enter a text string to associate with one IP address.
Enter an IP address, in dotted decimal format, to be mapped
to the name.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
727