Show Config (For Speed) - Dell S6000 Reference Manual

no shutdown
Dell(conf-if-fo-0/4)#

show config (for speed)

S6000
Syntax
show config
Command Dell(conf-if-te-2/10)#show config
Modes
Command
Version 9.3(0.1)
History
Example
Dell(conf-if-te-0/0)#speed ?
10 10 Mbps
100 100 Mbps
1000 1000 Mbps
Dell(conf-if-te-0/0)#speed 100
Dell(conf-if-te-2/10)#show config
interface TenGigabitEthernet 2/10
speed 100
no shutdown
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
S6000
Syntax
show config
Command CONFIGURATION INTERFACE (conf-if-range)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Interfaces
Introduced on the S6000.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
663