Remote Monitoring (Rmon) - Dell S6000 Reference Manual

Remote Monitoring (RMON)

The Dell Networking operating software remote monitoring (RMON) is implemented on the S6000
platform.
Dell Networking OS RMON is based on IEEE standards, providing both 32-bit and 64-bit monitoring and
long-term statistics collection. Dell Networking OS RMON supports the following RMON groups, as
defined in RFC-2819, RFC-3273, and RFC-3434:
• Ethernet Statistics Table; RFC-2819
• Ethernet Statistics High-Capacity Table; RFC-3273, 64bits
• Ethernet History Control Table; RFC-2819
• Ethernet History Table; RFC-2819
• Ethernet History High-Capacity Table; RFC-3273, 64bits
• Alarm Table; RFC-2819
• High-Capacity Alarm Table (64bits); RFC-3434, 64bits
• Event Table; RFC-2819
• Log Table; RFC-2819
Dell Networking OS RMON does not support the following statistics:
• etherStatsCollisions
• etherHistoryCollisions
• etherHistoryUtilization
NOTE: Only SNMP GET/GETNEXT access is supported. Configure RMON using the RMON
commands. Collected data is lost during a chassis reboot.
rmon alarm
Set an alarm on any MIB object.
S6000
Syntax
rmon alarm number variable interval {delta | absolute} rising-
threshold value event-number falling-threshold value event-
number [owner string]
To disable the alarm, use the no rmon alarm number command.
Parameters
number
Remote Monitoring (RMON)
Enter the alarm integer number from 1 to 65535. The value
must be unique in the RMON alarm table.
42
1189