Version 7.5.1.0
Usage
By default, Dell Networking OS distributes incoming traffic based on a hash
Information
algorithm using the following criteria:
•
•
•
•
load-balance hg
Choose the traffic flow parameters the hash calculation uses while distributing the traffic across internal
higig links.
S6000
Syntax
[no] load-balance hg { ip-selection | ipv6-selection [source-ip
| source-ipv6 | source-port-id | source-module-id | dest-ip |
dest-ipv6 | dest-port-id | dest-module-id | protocol | vlan |
L4-source-port | L4-dest-port ] | mac [source-mac | source-
port-id | source-module-id | dest-mac | dest-port-id | dest-
module-id | vlan | ethertype | source-dest-mac ] | tunnel
[ipv4-over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]}
Parameters
{ip-selection|
ipv6-selection
[source-ip |
source-ipv6 |
source-port-id
| source-
module-id |
dest-ip | dest-
ipv6 | dest-
port-id | dest-
module-id |
protocol | vlan |
L4-source-port
| L4-dest-port ]
IPv4 Routing
Introduced on the C-Series.
IP source address
IP destination address
TCP/UDP source port
TCP/UDP destination port
To use IPv4 key fields in hash computation, enter the
keyword ip-selection then one of the parameters. To use
IPv6 key fields in hash computation, enter the keyword
ipv6-selection then one of the parameters.
•
source-ip — Use IPv4 src-ip field in hash calculation.
•
source-ipv6 — Use IPv6 src-ip field in hash calculation
•
source-port-id — Use src-port-id field in hash
calculation.
•
source-module-id — Use src-module-id field in hash
calculation.
•
dest-ip — Use IPv4 dest-ip field in hash calculation.
•
dest-ipv6 — Use IPv6 dest-ip field in hash calculation
•
dest-port-id — Use dest-port-id field in hash calculation.
•
dest-module-id — Use dest-module-id field in hash
calculation.
•
protocol — Use IPv4 protocol field in hash calculation.
•
vlan — Use vlan field in hash calculation.
•
L4-source-port — Use IPv4 L4-source-port field in hash
calculation.
•
L4-dest-port — Use IPv4 L4-dest-port field in hash
calculation.
741