Dell S6000 Reference Manual page 1346

ipv6-address
vrf vrf-name
traps
informs
version 1 | 2c |
3
auth
noauth
priv
community-
string
1346
Enter the keyword host then the IPv6 address of the host in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Enter the keyword vrf and then the name of the VRF that
the SNMP server uses to connect to the host.
NOTE: You can use this attribute to inform the SNMP
engine about the vrf instance to be used to reach the
corresponding remote host to send Trap or Inform
message. If no VRF is specified, then the default VRF is
used.
(OPTIONAL) Enter the keyword traps to send trap
notifications to the specified host. The default is traps.
(OPTIONAL) Enter the keyword informs to send inform
notifications to the specified host. The default is traps.
(OPTIONAL) Enter the keyword version to specify the
security model then the security model version number 1,
2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter
64, which allows for integers twice the width of what is
normally allowed.
The default is version 1.
(OPTIONAL) Enter the keyword auth to specify
authentication of a packet without encryption.
(OPTIONAL) Enter the keyword noauth to specify no
authentication of a packet.
(OPTIONAL) Enter the keyword priv to specify both
authentication and then scrambling of the packet.
Enter a text string (up to 20 characters long) as the name of
the SNMP community.
NOTE: For version 1 and version 2c security models, this
string represents the name of the SNMP community. The
string can be set using this command; however, Dell
Networking OS recommends setting the community
string using the snmp-server community command
before executing this command. For version 3 security
model, this string is the USM user security name.
Simple Network Management Protocol (SNMP) and Syslog