Protocol Spanning-Tree - Dell S6000 Reference Manual

Version 7.5.1.0
pre-Version
6.2.1.1
Related
forward-delay
Commands
state.
hello-time

protocol spanning-tree

To enable and configure the spanning tree group, enter SPANNING TREE mode.
S6000
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree
stp-id command.
Parameters
stp-id
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
1402
Introduced on the C-Series.
Introduced on the E-Series.
— changes the wait time before STP transitions to the Forwarding
— changes the time interval between BPDUs.
Enter zero (0). Dell Networking OS supports one spanning
tree group, group 0.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Spanning Tree Protocol (STP)