Stack-Unit Stack-Group - Dell S6000 Reference Manual

Version 9.0.2.0
Version 8.3.11.1
Version 8.2.1.0
Version 7.6.1.0
E-Series
original
Command
Usage You must enable the stackable VLAN (using the vlan-stack compatible
Information
command) on the VLAN prior to adding a member to the VLAN.
Related vlan-stack compatible
Commands

stack-unit stack-group

Configure a stacking group specified by an ID.
S6000
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
unit-id
stack-group-id
[no]
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.10.2
VLAN Stacking
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
— enables stackable VLAN on a VLAN.
Enter the stack unit ID.
Enter the stack group ID. The range is from 0 to 16.
Use no stack-unit unit-id stack-group stack-id
to remove the current stack group configuration.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
1439