Dell S6000 Reference Manual page 865

vlan vlan-id
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example
mac-address-table static 00:01:00:00:00:01 {output Te 0/2 vlan
(Unicast)
2}
Example
mac-address-table static 01:00:5E:01:00:01 {multicast vlan
(Multicast)
2 output—range Te 0/2,Te 0/3}
Related show mac-address-table
Commands
Layer 2
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Introduced on the S6000.
Added support for output range parameter for S4810 and
Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the MAC address table.
865