Dell S6000 Reference Manual page 740

mac {dest-mac
| source-dest-
mac | source-
mac}
tcp-udp enable
ingress-port
enable
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.10.0
Version 8.3.7.0
Version 7.6.1.0
740
Enter the keywords to distribute MAC traffic based on the
following criteria:
• dest-mac — Uses the destination MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index
indicating which port the packet should be forwarded.
• source-dest-mac — Uses the destination and source
MAC address, VLAN, Ethertype, source module ID and
source port ID fields to hash. The hashing mechanism
returns a 3-bit index indicating which port the packet
should be forwarded.
• source-mac — Uses the source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index
indicating which port the packet should be forwarded.
Enter the keywords to distribute traffic based on the
following:
• enable — Takes the TCP/UDP source and destination
ports into consideration when doing hash computations.
This option is enabled by default.
Enter the keywords to distribute traffic based on the
following:
• enable — Takes the source port into consideration when
doing hash computations. This option is disabled by
default.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added the ingress-port parameter for the S4810.
Introduced on the S4810.
Introduced on the S-Series.
IPv4 Routing