Show Sflow - Dell S6000 Reference Manual

Defaults The Global default sampling.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.2.1.1
Usage This command changes the sampling rate for an interface. By default, the sampling
Information rate of an interface is set to the same value as the current global default sampling
rate. If the value entered is not a correct power of 2, the command generates an
error message with the previous and next power-of-2 value. Select one of these
two number and re-enter the command.
Related sflow sample-rate (Global)
Commands

show sflow

Display the current sFlow configuration.
S6000
Syntax
show sflow [interface]
Parameters
interface
sFlow
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— changes the sampling rate globally.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
1329