Lacp Ungroup Member-Independent - Dell S6000 Reference Manual

Command VLT DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Usage To delay the system from bringing up the VLT port for a brief period to allow IGMP
Information Snooping and Layer 3 routing protocols to converge, use the delay-restore
parameter. Use this feature:
•
•
Related show vlt statistics
Commands

lacp ungroup member-independent

Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
S6000
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel
vlt
Defaults Not configured.
Command CONFIGURATION
Modes
Virtual Link Trunking (VLT)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S8420T.
Introduced on the S4810.
after a VLT device is reloaded.
if the Peer VLT device was up at the time the VLTi link failed to the time when it
was restored.
— displays statistics on VLT operations.
Force all LACP port-channel members to become
switchports.
Force all VLT LACP members to become switchports.
1463