Distribute-List Out - Dell S6000 Reference Manual

Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.29.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Related ip prefix-list
Commands

distribute-list out

Configure a filter for outgoing routing updates.
S6000
Syntax
distribute-list prefix-list-name out [interface | bgp |
connected | isis |ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-
name
1168
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enters PREFIX-LIST mode and configures a prefix list.
Enter the name of a configured prefix list.
Routing Information Protocol (RIP)