Monitor Interface - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

When you configure keepalive, the system sends a self-addressed packet out of

the configured interface to verify that the far end of a WAN link is up. When you

configure no keepalive, the system does not send keepalive packets and so the

local end of a WAN link remains up even if the remote end is down.

monitor interface

Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five

seconds and the CLI prompt disappears.

monitor interface [interface]

To disable monitoring and return to the CLI prompt, press the q key.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.5.1.0

Version 8.3.7.0

Version 8.1.1.0

(OPTIONAL) Enter the following keywords and slot/port or

number information:

For the management port, enter the keyword

managementethernet then the slot (0 or 1) and the port

For a Tunnel interface, enter the keyword tunnel then

the slot/port. The range is from 1 to 16383.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN interface, enter the keyword vlan then the

slot/port. The range is from 1 to 4094.

EXEC Privilege

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the E-Series ExaScale.