Hardware-Address - Dell S6000 Reference Manual

Version 8.2.1.0

hardware-address

For manual configurations, specify the client hardware address.
S6000
Syntax
hardware-address address
Parameters
address
Defaults none
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
S6000
Syntax
host address
Parameters
address/mask
Defaults none
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Dynamic Host Configuration Protocol (DHCP)
Introduced on the C-Series and S-Series.
Enter the hardware address of the client.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter the host IP address and subnet mask.
531