Ip Ospf Retransmit-Interval - Dell S6000 Reference Manual

Use this command for interfaces connected to multi-access networks, not point-
to-point networks.

ip ospf retransmit-interval

Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the
interface.
S6000
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval
command.
Parameters
seconds
Defaults 5 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage Set the time interval to a number large enough to prevent unnecessary
Information retransmissions. For example, the interval must be larger for interfaces connected
to virtual links.
994
Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 5
seconds.
This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)