Per-Port Qos Commands - Dell S6000 Reference Manual

line rate traffic over the SP queue, it starves all other queues on the ports on which
this traffic is flowing.

Per-Port QoS Commands

Per-port QoS (port-based QoS) allows you to define the QoS configuration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic this interface receives.
S6000
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, use the no dot1p-
priority command.
Parameters
priority-value
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
1110
Enter a value from 0 to 7.
dot1p Queue Number
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Introduced on the S6000.
Introduced on the S4820T.
Quality of Service (QoS)