Show Qos Class-Map - Dell S6000 Reference Manual

Parameters
ip-dscp value
mac-dot1p
value
Defaults none
Command CONFIGURATION (conf-qos-policy-in)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
Information

show qos class-map

View the current class map information.
S6000
Syntax
show qos class-map [class-name]
Parameters
class-name
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
1134
(OPTIONAL) Enter the keywords ip-dscp then the IP DSCP
value. The range is from 0 to 63.
Enter the keywords mac-dot1p then the dot1p value. The
range is from 0 to 7.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
(Optional) Enter the name of a configured class map.
EXEC
EXEC Privilege
Introduced on the S6000.
Quality of Service (QoS)