Distribute-List In - Dell S6000 Reference Manual

ip-address
mask
prefix-list
Defaults weight = 115
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 6.3.1.0
Usage The administrative distance indicates the trust value of incoming packets. A low
Information administrative distance indicates a high trust rate. A high value indicates a lower
trust rate. For example, a weight of 255 is interpreted that the routing information
source is not trustworthy and should be ignored.

distribute-list in

Filter network prefixes received in updates.
S6000
Syntax
distribute-list prefix-list-name in [interface]
To return to the default values, use the no distribute-list prefix-list-
name in [interface] command.
Parameters
prefix-list-
name
interface
Intermediate System to Intermediate System (IS-IS)
(OPTIONAL) Enter an IP address in dotted decimal format
and enter a mask in either dotted decimal or /prefix format.
(OPTIONAL) Enter the name of a prefix list name.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced.
Specify the prefix list to filter prefixes in routing updates.
(OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
801