Dell S6000 Reference Manual page 850

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Use this command to confirm that the neighbor adjacencies are operating

correctly. If you suspect that they are not, you can verify the specified area

addresses of the routers by using the show isis neighbors command.

The following describes the show isis neighbors command shown in the

following example.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

EXEC Privilege

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

The value that identifies a system in an area.

The interface, slot, and port in which the router was

The value providing status about the adjacency state. The

range is Up and Init.

This value displays the adjacency type (Layer 2, Layer 2 or

IS-IS priority the neighbor advertises. The neighbor with

highest priority becomes the designated router for the

Displays the interfaces uptime.

Intermediate System to Intermediate System (IS-IS)