Ip Igmp Group-Join-Limit - Dell S6000 Reference Manual

Parameters
access-list
Defaults Not configured
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Usage The access list accepted is an extended ACL. To block IGMP reports from hosts, on
Information a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.

ip igmp group-join-limit

To limit the number of IGMP groups that can be joined in a second, use this feature.
S6000
Syntax
ip igmp group-join-limit number
Parameters
number
Defaults none
Command CONFIGURATION (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
608
Enter the name of the extended ACL (16 characters
maximum).
Enter the name of the extended ACL (139 characters
maximum).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on E-Series.
Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Internet Group Management Protocol (IGMP)