Show Interfaces Switchport - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

show interfaces

show interfaces switchport

Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode

interfaces' IEEE 802.1Q tag status and VLAN membership.

show interfaces switchport [interface | stack-unit unit-id ]

stack-unit unit-

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

— displays information on a specific physical interface or virtual

(OPTIONAL) Enter one of the following keywords and slot/

port or number information:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Enter the keyword backup to view the backup interface

for this interface.

(OPTIONAL) Enter the keywords stack-unit then the stack

member number. This option is available only on S-Series.

The range is from 0 to 5.

EXEC Privilege

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.