Service-Policy Input - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

qos-policy-output

service-policy input

Apply an input policy map to the selected interface.

service-policy input policy-map-name [layer2]

To remove the input policy map from the interface, use the no service-policy

input policy-map-name [layer2] command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

You can attach a single policy-map to one or more interfaces to specify the

service-policy for those interfaces. A policy map attached to an interface can be

policy-map-input

Quality of Service (QoS)

— creates a QoS output policy.

Enter the name for the policy map in character format (32

characters maximum). You can identify an existing policy

map or name one that does not yet exist.

(OPTIONAL) Enter the keyword layer2 to specify a Layer 2

Class Map. The default is Layer 3.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

NOTE: The service-policy commands are not allowed on a port channel.

The service-policy input policy-map-name command and the

service-class dynamic dot1p command are not allowed simultaneously

on an interface.

— creates an input policy map.