Protocol-Tunnel Rate-Limit - Dell S6000 Reference Manual

Version 8.3.11.1
Version 8.3.7.0
Version 7.4.1.0
Usage Dell Networking OS must have the default CAM profile with the default microcode
Information before you enable L2PT.

protocol-tunnel rate-limit

Enable traffic rate limiting per box.
S6000
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit
rate command.
Parameters
rate
Defaults 75 frames per second.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.4.1.0
Example
Dell#
Dell#conf
Dell(conf)#protocol-tunnel rate-limit 1000
Dell(conf)#
Service Provider Bridging
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the rate in frames per second. The range is from 75 to
3000. The default is 75.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series, E-Series TeraScale, and E-Series
ExaScale. Maximum rate limit on E-Series reduced from
4000 to 3000.
Introduced
1317