Hold-Time - Dell S6000 Reference Manual

hold-time

Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the
initialization of the VRRP MASTER, the new switch can stabilize its routing tables.
S6000
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
Parameters
seconds
centisecs
centisecs
Defaults zero (0) seconds or or (0) centiseconds
Command VRRP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Version 9.2(1.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage If a switch is a MASTER and you change the hold timer, disable and re-enable VRRP
Information for the new hold timer value to take effect.
Related disable
Commands
Virtual Router Redundancy Protocol (VRRP)
Enter the number of seconds. The range is from 0 to 65535.
The default is zero (0) seconds.
Enter the keyword centisecs then the number of centisecs
in units of 25 centisecs . The range is from 0 to 65525 in
units of 25 centisecs.
Added support for centisecs on the Z9000, S6000, S4820T,
S4810, and MXL.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— disables a VRRP group.
1499