Vlt Proxy Gateway - Dell S6000 Reference Manual

VLT Proxy Gateway

This chapter describes the VLT Proxy Gateway feature.
proxy-gateway lldp
Configure the LLDP proxy gateway
S6000
Syntax
proxy-gateway lldp
Command VLT DOMAIN
Modes
Command
Version 9.4(0.0)
History
Usage The configuration is cached and sent to LLDP only in one of the following
Information conditions:
1) The port-channel connecting the two VLT domains, across DC, must be a VLT
LAG
2) The protocol lldp command is globally enabled
3) The proxy-gateway LLDP configuration is applied.
However, "proxy-gateway lldp" configuration is sent to the Layer 2 application.
When LLDP sends an IPC reply message, SWPQ is created towards LLDP to send
further updates to LLDP. When the proxy gateway peer-domain-link port-channel
command is provisioned, the configuration is sent to LLDP if the port-channel is a
VLT port-channel. However it will not check whether the port-channel is up or
down. LLDP determines the addition and removal of LAG ports and transmits LLDP
packets out accordingly.
Example
Dell(conf)#vlt-domain 1
Dell(conf-vlt-domain#proxy-gateway lldp
1454
Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
55
VLT Proxy Gateway