Dell S6000 Reference Manual page 1038

Row Heading
Other-Q
The following describes the error definitions for the show ip ospf statistics
process-id global command.
Error Type
Intf_Down
Non-Dr
Self-Org
Wrong_Len
Invld-Nbr
Nbr-State
Auth-Error
MD5-Error
Cksum-Err
Version
AreaMismatch
Conf-Issue
No-Buffer
Seq-no
Socket
Q-overflow
Unknown-Pkt
Example
Dell#show ip ospf 1 statistics global
OSPF Packet Count
RX 10
TX 10
OSPF Global Queue Length
Hello-Q
1038
Description
The queue, for transmission or reception, for the link state
acknowledgement, database description, and update
packets.
Description
Received packets on an interface that is either down or
OSPF is not enabled.
Received packets with a destination address of ALL_DRS
even though SELF is not a designated router.
Receive the self originated packet.
The received packet length is different to what was
indicated in the OSPF header.
LSA, LSR, LSU, and DDB are received from a peer which is
not a neighbor peer.
LSA, LSR, and LSU are received from a neighbor with stats
less than the loading state.
Simple authentication error.
MD5 error
Checksum Error
Version mismatch
Area mismatch
The received hello packet has a different hello or dead
interval than the configuration.
Buffer allocation failure.
A sequence no errors occurred during the database
exchange process.
Socket Read/Write operation error.
Packets dropped due to queue overflow.
Received packet is not an OSPF packet.
Total Error Hello DDiscr LSReq LSUpd LSAck
0 8
0 10
TxQ-Len RxQ-Len Tx-Mark Rx-Mark
0 0
2 0 0
0 0 0
0 2
Open Shortest Path First (OSPFv2 and OSPFv3)
0
0