System Time And Date - Dell S6000 Reference Manual

System Time and Date

The commands in this chapter configure time values on the system, either using the Dell Networking
operating software, or the hardware, or using the network time protocol (NTP). With NTP, the switch can
act only as a client to an NTP clock host.
For more information, refer to the "Network Time Protocol" section of the Management chapter in the
Dell Networking OS Configuration Guide.
The commands in this chapter are generally supported on the S6000 with some exceptions, as notes in
the Command History fields.
calendar set
Set the time and date for the switch hardware clock.
S6000
Syntax
calendar set time month day year
Parameters
time
month
day
year
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
1410
Enter the time in hours:minutes:seconds. For the hour
variable, use the 24-hour format; for example, 17:15:00 is
5:15 pm.
Enter the name of one of the 12 months in English. You can
enter the name of a day to change the order of the display to
time day month year.
Enter the number of the day. The range is from 1 to 31. You
can enter the name of a month to change the order of the
display to time day month year.
Enter a four-digit number as the year. The range is from 1993
to 2035.
Introduced on the S6000.
51
System Time and Date