Ntp Multicast Client - Dell S6000 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0

ntp multicast client

To receive NTP information from the network via multicast, configure the switch.
S6000
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client
[multicast-address] command.
Parameters
multicast-
address
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1420
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter a multicast address. Enter either an IPv4
address in dotted decimal format or an IPv6 address in
X:X:X:X::X format. If you do not enter a multicast address, the
address:
• 224.0.1.1 is configured if the interface address is IPv4
• ff05::101 is configured if the interface address is IPv6
System Time and Date