Rate Shape - Dell S6000 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage
Information
S-Series
On one interface, you can configure the rate police command for a VLAN or
you can configure the rate police command for an interface. For each physical
interface, you can configure three rate police commands specifying different
VLANS.

rate shape

Shape the traffic output on the selected interface.
S6000
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps
rate
burst-KB
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
1112
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
NOTE: Per Port rate shape and rate police is supported for Layer 2 tagged and
untagged switched traffic and for Layer 3 traffic. Per VLAN rate shape and rate
police is supported on only tagged ports with Layer 2 switched traffic.
Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). On S-Series, make the value a multiple of
64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
The range is from 10 to 40000.
(OPTIONAL) Enter the burst size in KB. The range is from 0 to
10000. The default is 50.
Introduced on the S6000.
Introduced on the S4820T.
Quality of Service (QoS)