Debug Ip Bgp Soft-Reconfiguration - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage
To remove all configured debug commands for BGP, enter the no debug ip bgp
Information
command.

debug ip bgp soft-reconfiguration

Enable soft-reconfiguration debug.
Z9500
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group-
name] soft-reconfiguration
To disable, use the debug ip bgp [A.B.C.D | X:X:X:X::X | peer-group-
name] soft-reconfiguration command.
Parameters
vrf vrf-name
A.B.C.D
X:X:X:X::X
peer-group-
name
Defaults Disabled
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
400
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable soft-reconfiguration debugging on that
VRF.
(OPTIONAL) Enter the IPv4 address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter an IPv6 address.
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group..
Description
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Border Gateway Protocol