Debug Ip Bgp Updates - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.2.1.0
Usage
This command turns on BGP soft-reconfiguration inbound debugging. If no
Information
neighbor is specified, debug turns on for all neighbors.

debug ip bgp updates

Allows you to view information about BGP updates.
Z9500
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] updates [in | out | prefix-list prefix-list-
name]
To disable debugging, use the no debug ip bgp [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] updates [in | out | prefix-list
prefix-list-name] command.
Parameters
vrf vrf-name
A.B.C.D
X:X:X:X::X
peer-group
peer-group-
name
in
out
prefix-list
prefix-list-
name
ip-address
Border Gateway Protocol
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to view BGP updates information corresponding to
that VRF.
(OPTIONAL) Enter an IPv4 address of the neighbor.
(OPTIONAL) Enter an IPv6 address.
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
(OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
(OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
(OPTIONAL) Enter the keyword prefix-list then the
name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
401