Egress Interface Selection (Eis) Commands; Application - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Egress Interface Selection (EIS)

The following commands are Egress Interface Selection (EIS) commands.

Configure the management egress interface selection.

C9000 Series

application {all | application-type}

To remove a management application configuration, use the no application {all

| application-type} command.

application-type

Command Modes

EIS Mode (conf-mgmt-eis)

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

Enter any of the following keywords:

For DNS, enter the keyword dns.

For FTP, enter the keyword ftp.

For NTP, enter the keyword ntp.

For Radius, enter the keyword radius.

For sFlow collectors, enter the keyword sflow-

For SNMP (traps and MIB responses), enter the keywords

For SSH, enter the keyword ssh .

For Syslog, enter the keyword syslog.

For TACACS, enter the keyword tacacs.

For Telnet, enter the keyword telnet.

For TFTP, enter the keyword tftp.

Configure all applications.

Chapters

Table of Contents