Clear Ip Bgp Peer-Group - Dell Z9500 Command Reference Manual

Related
show debugging
Commands
show ip bgp flap-statistics
undebug all

clear ip bgp peer-group

Reset a peer-group's BGP sessions.
Z9500
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4
[multicast | unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name
peer-group-
name
ipv4 multicast
ipv4 unicast
ipv6 unicast
soft
in
out
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
— views the enabled debugging operations.
— views the BGP flap statistics.
— disables all debugging operations.
Enter the keyword vrf and then the name of the VRF to
reset the peer group corresponding to that VRF.
NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active state.
Enter the peer group name to reset the BGP sessions within
that peer group.
(OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to reset ipv4 multicast routes.
(OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to reset ipv4 unicast routes.
(OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to reset ipv6 unicast routes.
(OPTIONAL) Enter the keyword soft to reset soft
configuration.
Enter the keyword in to re-configure soft inbound updates.
Enter the keyword out to re-configure soft outbound
updates.
393