Egress Interface Selection (Eis) Commands; Application - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

If an IP address or VRRP group is assigned to the interface, you cannot use the

switchport command on the interface. To use the switchport command on an

interface, only the no ip address and no shutdown statements must be

listed in the show config output.

When you enter the switchport command, the interface is automatically added

to the default VLAN.

To use the switchport backup interface command on a port, first enter the

switchport command. For more information, refer to the "Configuring

Redundant Links" section in the "Layer 2" chapter of the Dell Networking OS

Configuration Guide.

Egress Interface Selection (EIS) Commands

The following commands are Egress Interface Selection (EIS) commands.

Configure the management egress interface selection.

application {all | application-type}

To remove a management application configuration, use the no application

{all | application-type} command.

application-

Enter any of the following keywords:

For DNS, enter the keyword dns.

For FTP, enter the keyword ftp.

For NTP, enter the keyword ntp.

For Radius, enter the keyword radius.

For sFlow collectors, enter the keyword sflow-

For SNMP (traps and MIB responses), enter the keywords

For SSH, enter the keyword ssh .

For Syslog, enter the keyword syslog.

For TACACS, enter the keyword tacacs.

For Telnet, enter the keyword telnet.

For TFTP, enter the keyword tftp.

Configure all applications.