Table 2-5 Error Code 3-3 Paper Jam Clear Area A - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RAP 2-2
Error Code C3-3
There is a paper jam between Paper Tray 3 and the Registration Sensor.
Logic Control on the Print Engine Controller Board sensed that when paper was fed from
Tray 3, the Registration Sensor did not actuate within the specified time after the Tray 2
Take Away Sensor actuated.

Table 2-5 Error Code 3-3 Paper Jam Clear Area A

Step Actions and Questions
1 PAPER INSPECTION
Inspect the paper that is loaded in the paper tray.
Is the paper loaded in the cassette wrinkled or
damaged?
PAPER PATH INSPECTION
2
Inspect the paper path for paper scraps or foreign
objects that could cause a paper jam.
Is the paper path clear?
3 REGISTRATION SENSOR TEST
1. Enter Diagnostic Mode.
2. From the Main Menu, select Comp Output Test / IOT
Unit / Reg. Sensor.
3. Press [4] to start test, [0] to stop.
4. Insert, then remove, a sheet of paper into the
Registration Sensor.
Does the Control Panel display "With Paper"
when you insert the paper into the
Registration Sensor, and does the display
"Without Paper" when you remove the paper?
4 TRAY 2 TAKE AWAY ROLLER CHECK
1. Enter Diagnostic Mode.
2. From the Main Menu select, Comp Output Test / IOT
Unit / Main Motor On.
3. Press [4] to start, [0] to stop.
4. Open Door B to observe the rollers.
Does the Take Away Roller 2 rotate when you
run the Main Motor?
5 TRAY 2 TAKE AWAY SENSOR TEST
1. Enter Diagnostic Mode.
2. From the Main Menu, select Comp Input Test / IOT
Unit / T/A Roll2 Sensor.
3. Press [4] to start test, [0] to stop.
4. Insert, then remove, a sheet of paper into the Tray 2
Take Away Sensor.
Does the Control Panel display "With Paper"
when you insert the paper into the Tray 2 Take
Away Sensor, and does the Control Panel
display "Without Paper" when you remove the
paper?
Volume 2 / High Capacity Feeder - Error Codes
Paper Jam
Clear Area A
Yes
Replace the
paper with
new paper
Go to step 3
Go to step 4
Go to step 5
Go to step 6
No
Go to step 2
Clear the
paper path
Replace the
Registration
Sensor [PL
6.1]
Replace
Tray 2
Feeder
[RRP 1-22
Tray 2
Feeder
Assembly
(PL 3.5)]
Replace the
Tray 2 Take
Away
Sensor [PL
5.1].
2-375