Rep 4.20 Cutter Crank Pulley; Rep 4.21 Cutter Clutch - Xerox Telecopier 7017 Technical Reference Manual

REP 4.20 Cutter Crank Pulley

Parts List on PL 4.4
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
6. Remove recording paper.
7. Remove lower paper guide assembly (REP
4.5).
8. Remove printer motor cover (REP 4.6).
9. Remove upper printer assembly (REP 4.7).
10. Remove cutter (REP 4.9).
11. Remove printer output drive roller (REP
4.10).
12. Remove pressure roller assembly (REP
4.11).
13. Remove thermal head assembly (REP
4.12).
14. Remove cutter crank arm (REP 4.13).
15. Remove cutter belt.
16. Remove cutter crank pulley. (Figure 1)
a. Remove E-ring securing the cutter
crank pulley.
b. Remove the cutter crank pulley.
c. Remove both cutter crank bearings.
REP 4.20, 4.21
Replacement
1. Reinstall cutter crank pulley.
a. Position one of the cutter crank
bearings on the cutter crank pulley.
b. Reposition cutter home lever and
hold until cutter crank
repositioned.
c. Reinstall both bearings and cutter
crank pulley with detent positioned
at cutter home lever.
d. Reinstall E-ring to secure cutter crank
pulley.
2. Reinstall remaining components
reverse order.
12/88
4-38
www.printcopy.info

REP 4.21 Cutter Clutch

Parts List on PL 4.4
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
6. Remove recording paper.
7. Remove lower paper guide assembly (REP
4.5).
8. Remove printer motor cover (REP 4.6).
9. Remove upper printer assembly (REP 4.7).
10. Remove cutter (REP 4.9).
pulley is
in
Continued
Telecopier 7017 / 7017SF