REP 12.10 2000 Sheet Feeder PWB
Parts List on PL 12.2
Removal
These components are susceptible to electrostatic discharge. Observe all ESD procedures to
avoid damage.
Switch off the power and disconnect the Power Cord.
1.
Remove the Lower Rear Cover (REP 12.4).
2.
Disconnect P/J601, P/J602, P/J603, P/J604, P/J605, P/J606, and P/J607 (Figure 1).
3.
Remove the four screws that secure the PWB (Figure 1).
4.
Remove the PWB (Figure 1).
Figure 1 2000 Sheet Feeder PWB
Replacement
1.
Reinstall the components in the reverse order.
Repair-Adjustment
REP 12.10, REP 12.11
CAUTION
WARNING
REP 12.11 Tray Lift Motor Assembly
Parts List on PL 12.2
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the Lower Rear Cover (REP 12.4).
2.
Open the 2000 Sheet Feeder tray.
3.
Disconnect P/J605 from the PWB (Figure 1).
4.
Remove the three screws that secure the Lift Motor Assembly (Figure 1).
5.
Remove the Tray Lift Motor Assembly (Figure 1).
Figure 1 Tray Lift Motor Assembly
Replacement
1.
Reinstall the components in the reverse order.
02/2000
4-82
WARNING
DocuPrint N2025/N2825
Initial Issue