RRP 2-33Tray 5 Feed, Pick and Retard Rollers
(PL 12.9~PL 12.10)
Fig 2-40 Tray 5 Feed, Pick and Retard Rollers
Replace the Feed, Pick and Retard Rollers as a unit.
Note
Removal
1.
Remove Tray 4 and slide out Tray 5.
2.
Slide the Chute forward so it clears the Rollers.
3.
Pull out on the Retard Roller latch and slide the Retard Roller off of the shaft.
4.
Repeat step 3 for the Pick and Feed Rollers.
Replacement
1.
Position the Roller with the latch end facing out, and slide the Roller onto the
Feed shaft.
2.
Rotate the Roller so the end tabs line up with the slots on the shaft One-Way
Clutch (PL12.9.6) and push the Roller down the shaft until the latch locks the
Roller into place.
3.
Repeat steps 1 and 2 for the Pick and Retard Rollers.
4.
Slide the Chute back into position.
5.
Reinstall Tray 4.
Roller
Roller Latch
Volume 2 / High Capacity Feeder - RRPs
Tab
Slot
S4525-229
2-455