Rep 4.7 Electronics Module Fan; Rep 4.8 Head Tilt Gear - Xerox ColorQube 8570 Service Manual

REP 4.7 Electronics Module Fan

Parts List on PL 4.1 Item 7
Removal
1. Remove the Control Panel Cover (REP
2. Remove the Left Side Cover (REP
3. Disconnect the Fan wiring harness connector
4. Remove 2 screws (plastic, T-20) that secure the Electronics Module Fan to the chassis.
5. Remove the Electronics Module Fan.
Figure 1 Removing the Electronics Module Fan
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
1.5).
1.10).
P/J105 from the Left Side Harness.

REP 4.8 Head Tilt Gear

Parts List on PL 4.1 Item 8
Removal
1. Remove the Control Panel Cover
2. Remove the Left Side Cover
3. Remove the Right Side Cover
4. Remove the Exit Cover (REP
5. Remove the Ink Loader (REP
6. Remove the Funnel Cap
7. Remove the Jetstack Cap
8. Remove the Printhead (REP
9. Remove the KL-Clip from the left side.
10. Remove the Waste Tray (REP
11. Remove the X-Axis Bias Spring
October 2012
4-75
(REP 1.5).
(REP 1.10).
(REP 1.11).
1.7).
1.8).
(REP 2.1).
(REP 2.2).
2.3).
Figure 1 Removing the KL-Clip
1.15).
(REP 2.24).
Repairs and Adjustments
REP 4.7, REP 4.8