Exit
REP 17.1 Exit Assembly
PL17.1.1
Phaser 7500 Printer Service Manual
1. Remove the Exit Cover (REP 19.5,
2. Open the Chute on the Fuser.
3. Release the wiring harness that is connected to the Exit Assembly from the
clamp and disconnect the wiring harness connector.
4. Remove 2 screws (silver, 8mm) that secure the Exit Assembly to the printer.
5. Raise the left side of the Exit Assembly, release the 3 tabs, and remove the Exit
Assembly.
Service Parts Disassembly
page
8-216).
Exit Assembly
Chute
s7500-241
8-179