Lacp System-Priority; Link-Aggregation Mode - H3C S5120-SI Series Command Reference Manual

Parameters
port-priority: Port LACP priority, in the range of 0 to 65535. The smaller this value, the higher the LACP
priority.
Description
Use the lacp port-priority command to set the LACP priority of a port.
Use the undo lacp port-priority command to restore the default.
The default LACP priority of a port is 32768.
Examples
# Set the port LACP priority of Gigabitethernet 1/0/1 to 64.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-Gigabitethernet1/0/1] lacp port-priority 64

lacp system-priority

Syntax
lacp system-priority system-priority
undo lacp system-priority
View
System view
Default Level
2: System level
Parameters
system-priority: LACP priority of the local system, in the range of 0 to 65535. The smaller this value, the
higher the system LACP priority.
Description
Use the lacp system-priority command to set the LACP priority of the local system.
Use the undo lacp system-priority command to restore the default.
By default, the system LACP priority is 32768.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64

link-aggregation mode

Syntax
link-aggregation mode dynamic
1-10